LR-4A Arm Kit
Fits DLR-6 and DLR-6P
Reach farther and gain inside access to chassis lift points with this optional Dannmar LR-4A Arm Kit. Raising a vehicle from a low-rise lift sometimes requires reaching various chassis points that are vertically difficult to contact. If the necessary lifting areas on a low-rise lift do not set in line with the lift points, this kit provides farther reach toward the center of the chassis to contact areas that do.
Downloads
Overview
Gain Low-Rise Lift Reach with this Arm Kit
The Dannmar LR-4A Arm Kit is easy to install. By simply slipping the arms into position, each arm engages and locks around the existing ramp’s outer edge to reach (toward the center of the undercarriage) the proper lifting area. And with the Dannmar LR-4A Arm Kit’s easy-slide engineering, you can simply and quickly move the arms fore or aft along each ramp to optimal locations.
This Dannmar LR-4A Arm Kit comes complete with four lift arms and four polyurethane rubber blocks. The rubber blocks are designed to grip the frame of the vehicle and to hold it strongly in position. They are also designed to withstand rugged use. With the Dannmar LR-4A Arm Kit in place, your scissor lift has the versatility to reach the lifting points of the most challenging chassis in your shop.
Features
- Fits models DLR-6 and DLR-6P
- Increases pad width of the ramps
- Slips securely into a locked position
- Easy to install and use
Specs
Fits | DLR-6 and DLR-6P |
---|---|
SKU# | 5210944 |
Overall Arm Length | 28” (716 mm) |
Extended Arm Length | 10” (254 mm) |
Arm Channel Depth | 1.25” (33 mm) |
Low Rubber Blocks Height | 3” (75 mm) |
Tall Rubber Blocks Height | 6” (152 mm) |
WARNING: California's Proposition 65